Barbed pipe fittings should only be used with LDPE Pipe ( Low density polyethylene pipe). Low density polyethylene pipe can be used on the surface or just below the surface. The pipe is 4 bar rated and the fittings are 6 bar rated.
Installation tips
The LDPE pipe will need to be warm prior to the installation of a barbed fitting. This will make sure that the fitting is easy to push in and will allow the pipe to shrink back on to the barbs making a tough durable and reliable fitting
Barbed Stopend 32mm Barbed Stop End 32 mm is suitable for use with LDPE 32 mm outside diameter pipe. Once fitted the joint is pressure rated to 6 bar because of...
Barbed Straight Connector 32mm Barbed joint 25 mm is suitable for use with LDPE 32 mm outside diameter pipe. Once fitted the joint is pressure rated to 6 bar because...
Barbed Tee Joint 32mm Barbed tee joint 32 mm is suitable for use with LDPE 32 mm outside diameter pipe. Once fitted the joint is pressure rated to 6 bar...
Barbed Push Fit Tee 32mm x32mm x 1" Male BSP Thread The barbed male Tee to 32mm push fit barbs are used exclusively with LDPE pipe. This is a thinner...
Barbed Elbow 32mm x 1" BSP Male Thread Barbed elbow joint 32 mm is suitable for use with LDPE 32 mm outside diameter pipe. Once fitted the joint is pressure...
Barbed Elbow 32 mm Barbed elbow joint 32 mm is suitable for use with LDPE 32 mm outside diameter pipe. Once fitted the joint is pressure rated to 6 bar...
Barbed Connector 32mm - 1" Male BSP Thread Barbed Connector joint 32 mm is suitable for use with LDPE 32 mm outside diameter pipe. Once fitted the joint is pressure...
Barbed Tee -3/4" Male Threaded Branch A barbed Tee fitting with a 3/4" male BSP thread. The large barbs make sure that the fitting once fitted stays fitted unlike other...
Barbed 16mm Control Valve The barbed control valve is ideal for restricting flow or turning off the flow to certain parts of the system. The valve can be used in...
Barbed Tee Joint 20mm - 1/2 Inch Bsp Threaded Branch Quick and simple installation Made from industrial grade plastic Will withstand pressures up to 120 psi Stronger than standard fittings...
Stopend 16mm with 3/4" Threaded Cap Simply push in to 16mm supply tube To extend the systems simply remove the threaded cap and screw on a threaded tap connector. ...
Tee 16mm 3/4" Threaded Branch Barbed plastic pipe fittings Pressure tested to 90 psi Needs heat to fit, hot water or paint stripper Lightly heat end of Black pipe...
Subscribe To Our Newsletter
Choosing a selection results in a full page refresh.
