Unidelta Compression Tee 63mm Made in Italy WRAS Approved Tee 63mm Strong secure grip ring Seal formed via O ring rather than rubber flap The seal in Unidelta fittings is...
The seal in Unidelta fittings is formed by an O ring rather than a rubber flap and this makes it much easier to fit if the pipes do not quite align.
Fitting instructions
Remove the blue nut and slide this over the pipe
Slide the white grip ring over the pipe and slide it back from the pipe end
Make sure that the cut end of the pipe is square and clean. A bevel can be shape on to the pipe and this will make it easier to fit the fitting
To ease installation a silicon gel can be applied to the end of the pipe and the O ring
Push the pipe inside the fitting. The pipe will stop when it touches the O Ring
Now push again and you will feel the pipe slide over the O ring. The pipe will slide beyond the O ring by between 12 and 20mm depending on the size of the fitting being used.
Slide the white grip fitting up to the fitting
Pull the blue nut down and tighten the fitting. Tighten the fitting so that it is hand tight and now continue to tighten the blue nut with some grips. Do not over tighten the fitting
Subscribe To Our Newsletter
Choosing a selection results in a full page refresh.
